HP ProCurve 1810G Management And Configuration Manual page 60

Link Layer Discovery Protocol (LLPD)
LLDP Configuration
Table 8-1. LLDP Configuration Fields
Field
Transmit Interval
Transmit Hold
Re-Initialization Delay
Notification Interval
Interface
Transmit Enable
Receive Enable
Enable Notification
Transmit Mgmt Info
■
To view LLDP statistics, click Status > LLDP Statistics in the navigation pane.
8-2
Description
Specify the interval at which frames are transmitted. The default is 30 seconds, and the
valid range is 5–32768 seconds.
Specify the multiplier on the transmit interval to assign to TTL (range 2–10, default = 4).
Specify the delay before a re-initialization (range 1–10 seconds, default = 2).
Specify a limit for the transmission of notifications (range 5–3600 seconds, default = 5).
The port to be affected by these parameters.
Enable or disable the transmission of LLDP PDUs. The default is enabled.
Enable or disable the ability of the port to receive LLDP PDUs. The default is enabled.
Enable to have LLDP generate a log file entry.
Enable or disable the transmission of management information with the LLDP PDUs. The
default is enabled.
Click Apply to save any changes for the current boot session; the changes take effect
immediately. Use the Maintenance > Save Configuration page to have the settings remain in effect
after a reboot.
Global
Interface