Simple Network Time Protocol - HP ProCurve 1810G Management And Configuration Manual

Simple Network Time Protocol

ProCurve 1810G switch software supports the Simple Network Time Protocol (SNTP). SNTP ensures
accurate network device clock time synchronization up to the millisecond. Time synchronization is
performed by a network SNTP server. The software operates only as an SNTP client and cannot provide
time services to other systems.
Note
SNTP acquires the Coordinated Universal Time (UTC) from an SNTP server. Configure the Time Zone
(see
To display the SNTP page, click Network Setup > SNTP in the navigation pane.
Figure 3-2. SNTP Page
Table 3-2. SNTP Fields
Field
Enable SNTP
SNTP/NTP Server
Server Port
Time Format
Current Time/Date
Attempts
Last Failure
Failures
page 3-4) and Daylight Savings Time (see
Description
Select to enable SNTP client mode. Clear to disable SNTP client mode. When disabled, the system
time increments from 00:00:00, 1 Jan 1970, which is set at bootup.
Specify the IP address of the SNTP server to send requests to.
Specify the server's UDP port to listen for responses/broadcasts (range 1–65535, default = 123).
Select either 24-hour ("military" time) format or 12-hour (standard) format.
The switch-adjusted time and date when delivered by the time server.
The number of requests made to the SNTP sever since the switch was rebooted.
The status of the last request to the SNTP server.
When this value is SNTP Server Error, the server cannot send further updates. You can
reconfigure the SNTP server with a new server address to get time updates.
The number of failed SNTP requests made to this server since last reboot.
page 3-5) to configure the offsets for your local time zone.
Network Setup
Simple Network Time Protocol
3-3