Configuration Examples; Establishing A Call Between Two Gateways - AudioCodes MediaPack MP-102 User Manual

8.9

Configuration Examples

8.9.1

Establishing a Call between Two Gateways

After you've installed and set up the MP-1xx, you can ensure that it functions as expected by
establishing a call between it and another gateway. This section exemplifies how to configure two
MP-108/FXS SIP gateways in order to establish a call. After configuration, you can make calls
between telephones connected to a single MP-108 gateway or between the two MP-108
gateways.
In the following example, the IP address of the first gateway is 10.2.37.10 and its endpoint
numbers are 101 to 108. The IP address of the second gateway is 10.2.37.20 and its endpoint
numbers are 201 to 208.
In this example, a SIP Proxy is not used. Call routing is performed using the internal 'Tel to IP
Routing' table.
To configure the two gateways, take these 4 steps:
Configure the following settings on the first MP-108 gateway (10.2.37.10):
1.
In the 'Endpoint Phone Numbers' screen, assign the phone numbers 101 to 108 for the
gateway's endpoints.
Configure the following settings on the second MP-108 gateway (10.2.37.20):
2.
In the 'Endpoint Phone Numbers' screen, assign the phone numbers 201 to 208 for the
gateway's endpoints.
Configure the following settings for both gateways:
3.
In the 'Tel To IP Routing' screen, in the first row, enter 10 in the 'Destination Phone
Prefix' field and enter the IP address of the first gateway (10.2.37.10) in the field 'IP
Address'. In the second row, enter 20 and the IP address of the second gateway
(10.2.37.20) respectively.
These settings enable the routing (from both gateways) of outgoing Tel IP calls that
start with 10 to the first gateway and calls that start with 20 to the second gateway.
Make a call! Pick up the phone connected to port #1 of the first MP-108 and dial 102 (to the
4.
phone connected to port #2 of the same gateway). Listen out for progress tones at the
calling endpoint and for ringing tone at the called endpoint. Answer the called endpoint, talk
into the calling endpoint, and check the voice quality. Dial 201 from the phone connected to
port #1 of the first MP-108 gateway; the phone connected to port #1 of the second MP-108
rings. Answer the call and check the voice quality.
MP-1xx SIP User's Manual 160
MP-1xx SIP
Document #: LTRT-65404