Figure 7-1: Call Progress Tone Types - AudioCodes MediaPack MP-102 User Manual

"Number of Call Progress Tones" defining the number of Call Progress Tones that are
defined in the file.
•
[CALL PROGRESS TONE #X] – containing the Xth tone definition (starting from 1 and not
exceeding the number of Call Progress Tones defined in the first section) using the following
keys:
Tone Type – Call Progress Tone type
- Dial Tone
1
2 - Ringback Tone
3 - Busy Tone
7 - Reorder Tone
8 - Confirmation Tone
9 - Call Waiting Tone
15 - Stutter Dial Tone
16 - Off Hook Warning Tone
17 - Call Waiting Ringback Tone
23 - Hold Tone
Low Freq [Hz] – Frequency in hertz of the lower tone component in case of dual
frequency tone, or the frequency of the tone in case of single tone.
High Freq [Hz] – Frequency in hertz of the higher tone component in case of dual
frequency tone, or zero (0) in case of single tone.
Low Freq Level [-dBm] – Generation level 0 dBm to –31 dBm in [dBm].
High Freq Level – Generation level. 0 to –31 dBm. The value should be set to '32' in the
case of a single tone.
First Signal On Time [10 msec] – "Signal On" period (in 10 msec units) for the first
cadence on-off cycle.
First Signal Off Time [10 msec] – "Signal Off" period (in 10 msec units) for the first
cadence on-off cycle.
Second Signal On Time [10 msec] – "Signal On" period (in 10 msec units) for the
second cadence on-off cycle.
Second Signal Off Time [10 msec] – "Signal Off" period (in 10 msec units) for the
second cadence on-off cycle.
Default Duration [msec] - The default duration (in 1 msec units) of the generated tone.
Note 1:
Note 2:
For example: to configure the dial tone to 440 Hz only, define the following text:
MP-1xx SIP User's Manual

Figure 7-1: Call Progress Tone Types

When the same frequency is used for a continuous tone and a cadence
tone, the 'Signal On Time' parameter of the continues tone must have a
value that is greater than the 'Signal On Time' parameter of the cadence
tone. Otherwise the continues tone is detected instead of the cadence tone.
The tones frequency should differ by at least 40 Hz from one tone to other
defined tones.
144
MP-1xx SIP
Document #: LTRT-65404