Configuring The Endpoint Phone Numbers; Figure 5-19: Endpoint Phone Number Table Screen; Table 5-18: Endpoint Phone Numbers Table - AudioCodes MediaPack MP-102 User Manual

MP-1xx SIP User's Manual
5.8.6

Configuring the Endpoint Phone Numbers

From the Endpoint Phone Numbers screen you can enable and assign telephone numbers, hunt
groups (optional) and profiles to the VoIP gateway ports.
To configure the Endpoint Phone Numbers table, take these 4 steps:
Open the 'Endpoint Phone Numbers Table' screen (Protocol Management menu >
1.
Endpoint Phone Numbers); the 'Endpoint Phone Numbers Table' screen is displayed.
Configure the Endpoint Phone Numbers according to
2.
in the Phone Number fields for each port that you want to use.
Click the Submit button to save your changes, or click the Register or Un-Register buttons
3.
to save your changes and to register / unregister to a Proxy / Registrar.
To save the changes so they are available after a power fail refer to Section
4.
139.
Parameter
Channel(s)
Phone Number
Version 4.4

Figure 5-19: Endpoint Phone Number Table Screen

Table 5-18: Endpoint Phone Numbers Table

Description
The numbers (1-8) in the Channel(s) fields represent the ports on the back of the VoIP
gateway.
To enable a VoIP gateway channel, you must enter the port number on this screen.
[n-m] represents a range of ports. For example, enter [1-4] to specify the ports from 1 to
4.
Note: For FXO gateways, the number of defined endpoints must not exceed the number
of connected physical lines.
In each of the Phone Number fields, enter the telephone number that is assigned to that
channel.
For a range of channels enter the first number in an ordered sequence.
These numbers are also used for port allocation for IP to Tel calls, if the hunt group's
'Channel Select Mode' is set to 'By Phone Number'.
Table
89
5. Configuring the MP-1xx
5-18. You must enter a number
5.12 on page
March 2005