Configuration Via Snmp; Figure 11-1: Example Of Entries In A Device Ini File Regarding Snmp - AudioCodes MediaPack MP-102 User Manual

MP-1xx SIP User's Manual

Figure 11-1: Example of Entries in a Device ini file Regarding SNMP

; SNMP trap destinations
; The board maintains a table of trap destinations containing 5 ;rows. The rows are
numbered 0..4. Each block of 4 items below ;apply to a row in the table.
; To configure one of the rows, uncomment all 4 lines in that ;block. Supply an IP
address and if necessary, change the port ;number.
; To delete a trap destination, set ISUSED to 0.
; -change these entries as needed
;SNMPManagerTableIP_0=
;SNMPManagerTrapPort_0=162
;SNMPManagerIsUsed_0=1
;SNMPManagerTrapSendingEnable_0=1
;
;SNMPManagerTableIP_1=
;SNMPManagerTrapPort_1=162
;SNMPManagerIsUsed_1=1
;SNMPManagerTrapSendingEnable_1=1
;
;SNMPManagerTableIP_2=
;SNMPManagerTrapPort_2=162
;SNMPManagerIsUsed_2=1
;SNMPManagerTrapSendingEnable_2=1
;
;SNMPManagerTableIP_3=
;SNMPManagerTrapPort_3=162
;SNMPManagerIsUsed_3=1
;SNMPManagerTrapSendingEnable_3=1
;
;SNMPManagerTableIP_4=
;SNMPManagerTrapPort_4=162
;SNMPManagerIsUsed_4=1
;SNMPManagerTrapSendingEnable_4=1
Note:

11.6.4.2 Configuration via SNMP

To configure trap destinations, the EM must use the snmpTargetMIB. Up to 5 trap destinations
can be configured.
To add a trap destination:
•
Add a row to the snmpTargetAddrTable with these values:
Name=trapN, TagList=AC_TRAP, Params=v2cparams, where N is an unused number
between 0 and 4.
All changes to the trap destination configuration take effect immediately.
To delete a trap destination:
•
Remove the appropriate row from the snmpTargetAddrTable.
To modify a trap destination:
(You can change the IP address and/or port number for an existing trap destination. The same
effect can be achieved by removing a row and adding a new row).
Version 4.4
The same information configurable in the ini file can also be configured via
the acBoardMIB.
189
11. SNMP-Based Management
March 2005