AudioCodes MediaPack MP-102 User Manual page 77

MP-1xx SIP User's Manual
Parameter
Destination IP Address
Profile ID
Status
Parameter Name in ini File Parameter Format
Prefix
Version 4.4
Table 5-11: Tel to IP Routing Table
Description
In each of the IP Address fields, enter the IP address that is assigned to these prefixes.
Domain names, such as domain.com, can be used instead of IP addresses.
To discard outgoing IP calls, enter 0.0.0.0 in this field.
Note: When using domain names, you must enter a DNS server IP address, or
alternatively define these names in the 'Internal DNS Table'.
Enter the number of the IP profile that is assigned to the destination IP address defined in
the 'Destination IP Address' field.
A read only field representing the quality of service of the destination IP address.
N/A = Alternative Routing feature is disabled.
OK = IP route is available
Ping Error = No ping to IP destination, route is not available
QoS Low = Bad QoS of IP destination, route is not available
DNS Error = No DNS resolution (only when domain name is used instead of an IP
address).
Prefix = <Destination Phone Prefix>,<IP Address>,<Source Phone Prefix>,<Profile ID>
For example:
Prefix = 20,10.2.10.2,202,1
Prefix = 10[340-451]xxx#,10.2.10.6,*,1
Prefix = *,gateway.domain.com,*
Note 1: <destination / source phone prefix> can be single number or a range of numbers.
For available notations refer to Section
Note 2: This parameter can appear up to 50 times.
Note 3: Parameters can be skipped by using the sign "$$", for example:
Prefix = $$,10.2.10.2,202,1
5.8.3.1 on page 71.
77
5. Configuring the MP-1xx
March 2005