Table 2-5: Mp-124 Rear Panel Component Descriptions; Table 2-6: Indicator Leds On The Mp-124 Rear Panel - AudioCodes MediaPack MP-102 User Manual

Item # Label
1
100-250 V~
2
50 - 60 Hz 2A
3 ANALOG LINES 1 –24
4 Data Cntrl Ready
5 RS-232
6 Eth 1 Eth 2
48 V
2A max
Note:
The Ethernet LEDs are located within each of the RJ-45 sockets.
Note that on the MP-124 the rear panel also duplicates the Data, Control and Ready LEDs from
the front panel.
Label Type
Packet Status
Data
Control Link
Cntrl
Device Status
Ready
Ethernet Status
Eth 1
Ethernet Status
Eth 2
MP-1xx SIP User's Manual

Table 2-5: MP-124 Rear Panel Component Descriptions

Protective earthing screw (mandatory for all installations).
AC power supply socket.
50-pin Telco for 1 to 24 analog lines.
LED indicators (described in
9 pin RS-232 status port (for Cable Wiring of the RS-232 refer to
3-10 on page 32).
Dual 10/100 Base-TX Ethernet connections.
Connection to external DC 40-60 V power supply (refer to
The Dual In-line Package
(supplied with some of the units), is not functional and should not be used.

Table 2-6: Indicator LEDs on the MP-124 Rear Panel

Color
Green
Red
Blank
Green
Blank
Green
Orange
Red
Green
Red
Green
Red
Component Description
Table 2-6).
( )
DIP switch, located on the MP-124 rear panel
State
Transmitting RTP Packets
ON
ON Receiving RTP Packets
No traffic
Blinking Sending and receiving H.323 messages
No traffic
Device Powered and Self-test OK
ON
ON Software Loading/Initialization
ON Malfunction
ON Valid 10/100 Base-TX Ethernet connection
ON Malfunction
Valid 10/100 Base-TX Ethernet connection
ON
ON Malfunction
24
MP-1xx SIP
Figure
Figure 3-9).
Function
Document #: LTRT-65404