Attendant Console Parameters - Cisco 501G Administration Manual

Configuring the Cisco SPA500S Attendant Console
Setting Up the Cisco SPA500S Attendant Console
STEP 5
STEP 6
Cisco SPA500 Series and WIP310 IP Phone Administration Guide
In the BLF List URI field, enter the URI to generate BLF keys:
listname@domain.com;vid=2
Where:
• listname: Name of the list.
• domain.com: Name of the domain.
• vid: Assigns keys to the extension. By default, the SUBSCRIBE is sent when
"Ext 1" is registered. You must set the "vid=" to a different value to change
this behavior.
For example:
mylist@broadsoft.com;vid=2
Click Submit All Changes.

Attendant Console Parameters

Parameters in the Attendant Console web page are described in the following
table. For information about Unit/Key syntax, see the previous sections.
.
Parameter
Subscribe Expires
Subscribe Retry Interval
Unit 1 Enable
Unit 2 Enable
Subscribe Delay
Description
Specifies how long the subscription remains valid.
After the specified period of time, elapses, the Cisco
SPA500S initiates a new subscription.
Defaults to 1800.
Specifies the length of time to wait to try again if
subscription fails.
Enables or disables the first Cisco SPA500S unit (each
phone can have up to two Cisco SPA500S units
attached).
Enables or disables the second Cisco SPA500S unit
(each phone can have up to two Cisco SPA500S units
attached).
Length of delay before attempting to subscribe.
Defaults to 1.
9
172