Getting Started
Prerequisites
Prerequisites
Cisco SPA500 Series and WIP310 IP Phone Administration Guide
Cisco Unified Communications 500 Series for Small Business
The Cisco Unified Communications 500 Series for Small Business is an affordable
appliance that provides voice, data, voice mail, Automated Attendant, video,
security, and wireless capabilities while integrating with existing desktop
applications such as calendar, e-mail, and customer relationship management
(CRM) programs. The Cisco SPA500 Series IP Phones can be configured to work
with this system.
Other SIP IP PBX Call Control Systems
The Cisco SPA500 Series and Wireless-G IP Phones are compatible with other IP
PBX call control systems, such as BroadSoft and Asterisk, that use SIP for call
processing. Configuration of those systems is not covered in this document.
Additional resources for configuring the Cisco SPA500 Series and Wireless-G IP
Phones to work with these systems are available in
From Here."
This document assumes that you have performed the following prerequisites
before administering your Cisco SPA500 Series and Wireless-G IP Phones. If you
have not completed these prerequisites, see the documentation in
"Where to Go From Here."
1. Set up your IP network.
2. Configure the wireless network (required for SPA525G and WIP310).
3. Install and configure the call control system, such as such as a SPA9000, Cisco
Unified Communications 500 Series for Small Business, or an Internet-based IP
PBX.
4. Update firmware. See
for more information.
Upgrading Firmware, page
Appendix C, "Where to Go
Appendix C,
7.
1
6