Configuring Wireless Settings; Configuring Common Wireless Settings - Ruckus Wireless ZoneFlex 7781CM User Manual

Configuring Wireless Settings

This section describes how to configure the wireless settings of the Access Point.
There are two types of wireless settings that you need to configure:
• Configuring Common Wireless
code, and advanced wireless settings, such as the wireless transmit power and
wireless protection mode. These settings are applied to all WLANs.
• Configuring Wireless #
Wireless 8 on the 2.4GHz radio and Wireless 9 through Wireless 16 on the 5GHz
radio) provide settings for customizing each WLAN individually.
Refer to the sections below for instructions on how to configure each set of wireless
settings.

Configuring Common Wireless Settings

Common wireless settings are settings that are applied to all WLANs. On single-
radio APs, go to Configuration > Wireless. On dual-radio APs, you configure these
settings for the 2.4GHz and 5GHz radios independently by going to Configuration
> Radio 2.4G or Configuration > Radio 5G.
1 Go to Configuration > Wireless/Radio 2.4G/Radio 5G. The Configuration >
Wireless > Common page appears.
Figure 33. The Configuration > Wireless > Common page
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B
Settings: Includes the wireless mode, country
Settings: The Wireless # tabs (Wireless 1 through
Configuring Wireless Settings
Configuring Common Wireless Settings
80