Configuring Wireless Settings - Ruckus Wireless ZoneFlex series User Manual

3. In Local IP Address, enter an IP address for the gateway. The default address for
Subnet 1 is 192.168.40.1. This address can be used to access the AP's web
interface for configuration and monitoring from devices connected to this subnet.
4. In Subnet Mask, typically you would want to leave the setting at its default value
(255.255.255.0) for a Class C subnet with an address pool of up to 254 addresses.
An error appears if you enter an invalid IP/netmask combination.
5. In DHCP Server, click Enabled if you want to enable DHCP for this subnet. Starting
Address and Maximum DHCP Users fields appear.
6. In Starting Address, enter an address in the same subnet as the Local IP Address
(e.g., 192.168.40.2).
7. In Maximum DHCP Users, enter the maximum number of clients that can be
assigned addresses by DHCP in this subnet (valid values are 1-253 if the default
subnet mask is used).
8. In Access VLAN, enter a VLAN ID to segment client traffic arriving from this subnet
from other network traffic. (Example: if you use the default 192.168.40.1 address
range, you may want to use "40" as the VLAN for this subnet.)
9. Click Update Settings to save your changes. The local subnet is created immediately
and can now be applied to WLANs or Ethernet ports from their respective configuration
pages.

Configuring Wireless Settings

This section describes how to configure the wireless settings of the AP.
There are two types of wireless settings that you need to configure:
• Configuring Common Wireless Settings
country code, and advanced wireless settings, such as the wireless transmit power
and wireless protection mode. These settings are applied to all WLANs.
• Configuring Wireless # (WLAN Number) Settings
( Wireless 1" through Wireless 8" on the 2.4 GHz radio and Wireless 9" through
Wireless 16" on the 5 GHz radio) provide settings for customizing each WLAN
individually.
Configuring Common Wireless Settings
Common wireless settings are settings that are applied to all WLANs.
On single radio APs, go to Configuration > Wireless. On dual radio APs, you configure
these settings for the 2.4 GHz and 5 GHz radios independently by going to Configuration
> Radio 2.4G or Configuration > Radio 5G.
1. Go to Configuration > Wireless. The Configuration > Wireless > Common page
appears.
ZoneFlex Indoor Access Point Release 104.0 User Guide
on page 99: Includes the wireless mode,
on page 104: The Wireless # tabs
Configuration
Configuring the AP
99