Resetting The Ap To Factory Defaults - Ruckus Wireless ZoneFlex 7781CM User Manual

Resetting the AP to Factory Defaults

WARNING!
directed to do so by Ruckus Wireless support staff or by a network administrator.
Do this only if you are able to immediately reconnect the restored AP to your
computer, to reconfigure it for Wi-Fi network use — as detailed in
ZoneFlex AP Web Interface" on page
You can use the Web User interface to restore an inoperative AP to its factory default
settings, which completely erases the configuration currently active in the device.
Note that this disrupts all wireless network communications through this device.
1 Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2 Click Reset now (next to Reset the AP to factory settings).
3 When the confirmation warning appears, read the message and click OK if you
are certain that you want to restore the AP to factory defaults.
After a brief pause, you are automatically logged out of the AP. You must now
disconnect the AP from the switch (and the network) and reconnect it to your
computer, as described in the associated AP Installation Guide. At this time, you
can restore the network settings, then replace it in your site for full network use.
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B
DO NOT reset the Access Point to factory defaults unless you are
Resetting the AP to Factory Defaults
64.
Scheduling Automatic Upgrades
"Logging Into the
133