Configuring the Access Point
Configuring Wireless Settings
Figure 32.
Configuring local subnets and enabling router mode
Configuring Wireless Settings
This section describes how to configure the wireless settings of the Access Point.
There are two types of wireless settings that you need to configure:
Configuring Common Wireless
■
code, and advanced wireless settings, such as the wireless transmit power and
wireless protection mode. These settings are applied to all WLANs.
Configuring Wireless #
■
"Wireless 8" on the 2.4GHz radio and "Wireless 9" through "Wireless 16" on the
5GHz radio) provide settings for customizing each WLAN individually.
Refer to the sections below for instructions on how to configure each set of wireless
settings.
Configuring Common Wireless Settings
Common wireless settings are settings that are applied to all WLANs. On single radio
APs, go to Configuration > Wireless. On dual radio APs, you configure these settings
for the 2.4GHz and 5GHz radios independently by going to Configuration > Radio
2.4G or Configuration > Radio 5G.
Settings: Includes the wireless mode, country
Settings: The Wireless # tabs ("Wireless 1" through
62