Navigating The Web Interface; Logging Into The Zoneflex Ap Web Interface - Ruckus Wireless ZoneFlex 7781CM User Manual

Navigating the Web Interface

In this chapter:
•

Logging Into the ZoneFlex AP Web Interface

• Navigating the Web Interface
• When Using a Dual-Band Access Point
Logging Into the ZoneFlex AP Web Interface
You can manage your AP with the ZoneFlex Web interface (which you already used
to configure basic AP parameters). If your ZoneFlex network is managed by a
Ruckus Wireless ZoneDirector, then you can manage APs using ZoneDirector rather
than individually logging into each AP's Web interface.
NOTE The following procedure assumes that you know the static IP address of
the AP (now in use), or you have some means of determining the dynamic IP address
in use by the AP. The PC you use for AP administration should be on the
management VLAN, if VLANs are used in your network.
Refer to the outdoor access point installation guide for instructions on how to
connect an administrative computer to the AP.
1 On the PC, open a Web browser window.
2 In the address or location bar, type the IP address of the AP. Default IP address
for standalone ZoneFlex APs:
192.168.0.1
3 Press <Enter> to connect to the Web interface.
4 If a Windows security alert dialog box appears, then click Yes or OK or Proceed
anyway (depending on the browser) to continue. The Ruckus Wireless Admin
login page appears.
5 In Username, type
6 In Password, type
7 Click Login.
The ZoneFlex Access Point Web interface appears.
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B
192.168.100.2
(or
super
.
sp-admin
.
for Cable Modem APs)
2
64