Configuring Device Settings - Ruckus Wireless ZoneFlex 7781CM User Manual

Configuring Device Settings

Device settings refer to the device name, location, temperature update, service
provider login, and other settings. (Some settings are only available on certain
ZoneFlex models.)
1 Go to Configuration > Device.
Figure 28. The Configuration > Device page
2 In Device Name, type a new name for the device or leave as is to accept the
default device name (RuckusAP). The device name identifies this access point
among other devices on the network.
3 Configure the following optional settings as desired:
• Enter Device Location to keep track of the physical location of the AP.
• If the AP has a GPS antenna, then select the method of entering the GPS
coordinates. In Coordinate Source, select GPS to have the GPS antenna
automatically determine and enter the GPS coordinates, or select Manual
to enter the GPS coordinates manually.
If you selected Manual, then enter GPS Coordinates to record the physical
location of the AP.
• Under LED Control (specific models only), check the Disable Status LED(s)
box to turn off the status LEDs. This can be useful when the AP is installed
in a public location, to avoid drawing attention to the AP.
• Enable Internal Heater and PoE OUT Port (specific models only) if needed.
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B
Configuring Device Settings
68