Configuring An Ntp Server; Configuring The Management Vlan; Default Ip Addressing Behavior - Ruckus Wireless ZoneFlex 7781CM User Manual

Configuring Internet Settings

Configuring an NTP Server

AP Ethernet ports however, can be configured to pass all VLAN traffic (Trunk Ports)
or multiple specific VLANs (General ports).
The VLAN displayed in the Web interface shows the AP's view of the VLAN
environment; when a packet arrives at an AP's Ethernet port, the port's VLAN
configuration helps determine if the packet is accepted or not (VLAN membership),
and assigns a default VLAN (untagged VLAN) if the packet contains no 802.1Q
header.
In general, if your network has VLANs deployed already, you should apply VLAN
configuration to Ruckus APs so that the configuration across the network is
consistent.
Configuring an NTP Server
A network time protocol (NTP) server should be configured to ensure that the Access
Point maintains the correct time. The default Ruckus Wireless NTP Server
(ntp.ruckuswireless.com) can be used if you do not have an NTP server on your
network.
If you want the AP to use a different NTP server, you can do so by going to
Configuration > Internet, entering the host name in NTP Server at the top of the
page, and then clicking Update Settings.

Configuring the Management VLAN

NOTE Changing the Management VLAN causes you to be immediately
disconnected from the Web interface if the computer you are using is not on the
same VLAN. Do not change the Management VLAN unless your admin PC is on
the same VLAN, or you are disconnected and unable to connect again without
factory resetting the AP.
If you want to place this AP's management traffic into a management VLAN, enter
the VLAN ID in the Management VLAN field and click Update Settings.

Default IP Addressing Behavior

By default, the Access Point is configured to automatically obtain an IPv4 address
from a DHCP server on the network. If the Access Point does not detect a DHCP
server, it automatically assigns itself the static IP address 192.168.0.1 (or
192.168.100.2 for Cable Modem APs) to make it easier for you to configure and
deploy it on your network.
71
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B