Reviewing Common Advanced Settings - Ruckus Wireless ZoneFlex 7781CM User Manual

4 If you are using an Ekahau Real Time Location System (RTLS) in your
organization, then you can use your ZoneFlex AP to relay location or presence
data to the Ekahau Real Time Location System RTLS Controller (ERC).
• To enable the AP to relay Ekahau data, click Enabled in Ekahau Settings.
• If you have enabled Ekahau, then complete the following:
- ERC IP Address: Enter an IP address for the Ekahau Real Time Location
System RTLS Controller.
- ERC port: 65538 is the default, but it can be set to any available TCP port
used by the Ekahau Real Time Location System RTLS Controller.
NOTE For other Ekahau-related configuration, refer to the Ekahau documentation
that was shipped with your Ekahau Real Time Location System RTLS Controller.
5 Click Update Settings to save your changes.

Reviewing Common Advanced Settings

Advanced wireless settings should only be changed by an experienced adminis-
trator. Incorrect settings can severely impact wireless performance. It is recom-
mended that the default settings be retained for best performance.
NOTE To fully benefit from the Access Point's capabilities, it is advisable not to
change these values unless absolutely necessary.
1 On the Configuration > Wireless/Radio 2.4G/Radio 5G page, click Edit
Common Settings. The Configuration > Wireless > Advanced > Common page
appears.
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B
Configuring Wireless Settings
Configuring Common Wireless Settings
83