Table of Contents
Advertisement
Resetting the Access Point to Factory Default Settings
Configuring the 5GHz Antenna Gain
9
Resetting the Access Point to Factory
Default Settings
You can reset the AP to its factory default settings by pressing the reset button that is
located next to the RJ-45 PoE Out port.
1. Remove the middle (RJ-45) cable gland.
2. Locate the reset button next to the RJ-45 port.
3. Using a pen or a similar pointed object, press the button for 10 seconds.
4. Verify that the STATUS LED on the AP is off. If the STATUS LED is off, it indicates that
the reset process is complete.
You have completed resetting the AP to its factory default settings.
Figure 31.
Location of the reset button
50
Reset button
Advertisement
Table of Contents
