Table of Contents
Advertisement
Appendix B: Rebooting and
Resetting the T504
•
Rebooting and Resetting the AP and CM
•
Resetting the CM to Factory Default Settings
Rebooting and Resetting the AP and CM
CAUTION!
their factory default settings.
If you want to reset only the CM component to its factory default settings, then
perform the procedure described in
on page 45
CAUTION!
settings that you have previously configured. Also note that resetting and/or
rebooting the AP and CM disrupts all wireless network communications through
this device.
There are different ways to reboot or reset the AP and CM parts of the T504:
•
Using the Reset Button Inside the AP
•
Remotely Rebooting the AP
Using the Reset Button Inside the AP
You can reset the AP and CM to their factory default settings by pressing the reset
button located under the Reset button and diagnostic Ethernet port blanking cap
on the T504.
1 Make sure that the AP is powered.
2 Use a 7/16" (11mm) socket to remove the Reset button and diagnostic Ethernet
port cap. See
Ethernet port cap.
3 Locate the reset button under the Reset button and diagnostic Ethernet port
cap. See
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
Performing this procedure resets the AP and CM parts of the T504 to
instead.
Resetting the AP and CM to factory default settings erases all the
Figure 5
for the location of the Reset button and diagnostic
Figure 17
for the location of the reset button inside the T504.
"Resetting the CM to Factory Default Settings"
B
43
Advertisement
Table of Contents
