Resetting The Access Point To Factory Defaults - Ruckus Wireless ZoneFlex 2741 User Manual

Resetting the Access Point to Factory
Defaults
WARNING: DO NOT reset the Access Point to factory defaults unless you are
directed to do so by Ruckus Wireless support staff or by a network administrator. Do
this only if you are able to immediately connect the restored AP to your computer, to
reconfigure it for Wi-Fi network use.
You can use the Web User interface to restore an inoperative AP to its factory default
settings, which will completely erase the configuration currently active in the AP. Note,
too, that this will disrupt all wireless network communications through this AP.
To reset the Access Point to factory defaults
1. Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2. Click Reset now (next to Restore to factory settings?).
3. When the confirmation warning appears, read the message and click OK if you
are certain that you want to restore the AP to factory defaults.
After a brief pause, you will be automatically logged out of the AP. You must now
disconnect the AP from the switch (and the network) and reconnect it to your
computer, as described in the associated AP Installation Guide. At this time, you can
restore the network settings, then replace it in your site for full network use.
Managing the Access Point

Resetting the Access Point to Factory Defaults

97