Table of Contents
Advertisement
10
Resetting the CM to Factory Default
Settings
You can also use SNMP on either the access point or cable modem to reset the CM to
factory default settings. The procedure is the same, regardless whether you perform this
operation from the AP or CM.
Performing this procedure resets only the CM component to its factory default
CAUTION:
settings. If you want to reset both the CM and AP components to factory default settings,
perform the procedure described in
on page 40 instead.
Before You Begin
Before starting this procedure, you must first obtain the following:
The IP address that is assigned to the access point that you want to reset to factory
■
default settings. You can obtain this information from the DHCP server on the network.
Obtain the related MIBs from Ruckus Wireless. Contact your authorized Ruckus
■
Wireless sales representative or Ruckus Wireless Support. For the Ruckus Wireless
Support contact information, visit the following Web address:
http://support.ruckuswireless.com/contacts
To reset the access point to factory defaults using SNMP
1. Connect the administrative computer to the same network as the cable modem.
2. Start your MIB browser.
3. Load the Ruckus Wireless MIBs onto the MIB browser.
4. In the MIB browser, specify the IP address of the cable modem that you want to reset
to factory default settings.
5. Find the OID 1.3.6.1.4.1.25053.3.1.4.7.3 (ruckusZF7761CMControlLED).
6. Set the value to 15 (factoryResetCM).
You have completed resetting the cable modem to factory default settings using SNMP.
Resetting the CM to Factory Default Settings
Using SNMP to Reset the Access Point
"Using the Reset Switch on the DC Power Supply"
43
Advertisement
Table of Contents
