Mpls Traffic-Eng Tunnels(Global Configuration); Mpls Traffic-Eng Tunnels(Interface Configuration) - Zte ZXR10 Command Manual

ZXR10 Command Manual (MPLS Volume)
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
84 Confidential and Proprietary Information of ZTE CORPORATION
It is implicit-null configuration by default.
� If the function is enabled on a node, and this node as the trail-
ing node of the tunnel distributes a implicit-null label 3 to the
last but one hop. If this function is disabled on the interface,
a implicit-null label 0 is distributed tothe last but one hop.
�
Restore the default implicit-null configuration with the no form
of this command. If there is the force parameter after the
no form of this command, then the new configuration will take
effect on all tunnels (the created and new tunnels). If there is
no force parameter after the no form of this command, then
it only takes effect on the new tunnel.
This example describes how to configure RSVP implicit-null func-
tion.
ZXR10(config)#mpls traffic-eng signalling advertise implicit-null
mpls traffic-eng
tunnels(Global
Configuration)
Use this command to enable MPLS traffic engineering signalling.
Disable the function with the no form of this command.
Global configuration
mpls traffic-eng tunnels
no mpls traffic-eng tunnels
MPLS traffic engineering is not supported by default..
To enable the router to support MPLS traffic engineering, users
must configure this command in the global configuration mode and
enable MPLS traffic engineering on the related interfaces.
This example describes how to enable MPLS TE.
ZXR10(config)#mpls traffic-eng tunnels
mpls traffic-eng
tunnels(Interface
Configuration)
Use this command to enable MPLS traffic engineering signalling
on a interface. Disable the function with the no form of this com-
mand.
Interface configuration