Stp-Tunnel Enable; Vcid - Zte ZXR10 Command Manual

ZXR10 Command Manual (MPLS Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
64 Confidential and Proprietary Information of ZTE CORPORATION
show vfi

stp-tunnel enable

Use this command to set stp tunnel in vfi.
Vfi configuration

stp-tunnel enable

no stp-tunnel enable
enable
The platform version 4.8.22 and upgrade versions support this
command.
Use this command to set VPLS stp tunnel.
This example describes how to set stp tunnel in vfi.
ZXR10(config-vfi)#stp-tunnel enable
no vfi
vid
pwtype
peer
no peer
vpls mac-filter

vcid

Use this command to specify a virtual channel identifier (VCID) for
the VPLS instance.
VFI configuration
vcid <vcid>
<vcid>
This command is supported after the platform version 4.6.02.
If VPLS instances on two PE routers belong to the same VPLS, a
pseudo wire (PW) must be established between the PEs for com-
munication of these VPLS instances. The pseudo wire (PW) is es-
Enables STP tunnel in vfi.
Different VPLS instances on the same PE
have different virtual channel identifiers
(VCIDs), and VPLS instances with the same
virtual channel identifier (VCID) on different
PEs belong to the same VPLS, range:
1~4294967296