Ip Rsvp Bfd - Zte ZXR10 Command Manual

Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Interface configuration
ip rsvp bandwidth <interface-kbps><perflow-kbps>[{bc1 <bc1
-bw-kbps>}]
no ip rsvp bandwidth
<interface-kbp>
<perflow-kbps>
<bc1-bw-kbps>
By default, this command is disabled. And the maximal usable
bandwidth of traffic engineering on the interface and that of an
LSP are 75% of the physical bandwidth.
The maximal bandwidth configured by this command is invalid if
the bandwidth occupied by the UP tunnel is larger than the config-
ured value. In this case, users must shut down the corresponding
UP tunnel to release the occupied bandwidth.
This example describes how to configure the maximum TE band-
width as 20000kbps, the maximum flow bandwidth as 2000kpbs.
ZXR10(config)#interface gei_1/1
ZXR10(config-if)#ip rsvp bandwidth 20000 2000

ip rsvp bfd

Use this command to configure RSVP Bidirectional Forwarding De-
tection (BFD) function on the interface. Delete the configuration
with the no form of this command.
Interface configuration

ip rsvp bfd

no ip rsvp bfd
The behavior of this command is disabled by default.
When there is no tunnel passing through this interface, Bidirec-
tional Forwarding Detection (BFD) sessions are not established
even if this command is configured.
This example describes how to configure Bidirectional Forwarding
Detection (BFD) function on the interface.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rsvp bfd
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 MPLS Traffic Engineering Configuration
1~10000000 Maximal bandwidth supporting
traffic engineering on the interface, unit:
kbps, range: 1~10000000
Maximal bandwidth of the flow the traffic
engineering passing through the interface,
unit: kbps, range: 1~10000000
Bcl bandwidth configured by the user, unit:
kbps, range: 1~10000000
75