Mpls Ldp Target-Session; Mpls Xconnect - Zte ZXR10 Command Manual

ZXR10 Command Manual (MPLS Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
28 Confidential and Proprietary Information of ZTE CORPORATION

mpls ldp target-session

Use this command to configure the address of the indirect remote
target session and establish the target session. To delete the ses-
sion, use the no form of this command.
Global configuration
mpls ldp target-session <ip-address>
no mpls ldp target-session <ip-address>
<ip-address>
This command is supported after the platform version 4.6.02.
This example describes how to establish a target session with the
router whose router identifier is 1.1.1.1.
ZXR10(config)#mpls ldp target-session 1.1.1.1
show mpls ldp neighbor

mpls xconnect

Use this command to configure the address, VPWS identifier, and
tunnel number of the remote interface. The creation of VPWS is
triggered between local interface and the remote interface. Delete
the VPWS with the no form of this command.
Interface configuration
mpls xconnect <ip-address><vc-id>[tunnel <tunnel number>]
no mpls xconnect
<ip-address>
<vc-id>
tunnel <tunnel
number>
�
This command is supported after the platform version 4.6.02.
� The vc-id must be unique among local nodes, and the corre-
sponding interface of the remote node must be assigned with
the same vc-id. The unique PW identifier throughout the net-
work is composed of the remote node address and the vd-id.
� If there is the tunnel parameter, MPLS labels are allocated by
the specified tunnel. If there is no tunnel parameter, MPLS
labels are allocated by LDP.
IP address or router identifier of the remote
neighbor
IP address of the remote interface or router
identifier of the remote node
VPWS identifier, range: 1~4294967295
Tunnel number used for creating VPWS,
range: 1~1024