Command Mode - Zte ZXR10 Command Manual

iv. Input a question mark after a command, a keyword or a
parameter, the next keyword or parameter to be input will
be listed, and also a brief explanation will be given. Note
that a space must be entered before the question mark.
2. If incorrect command, keyword or parameter is input, the error
isolation is offered with ^ in the user interface after you press
ENTER. The ^ is below the first character of the input incorrect
command, keyword or parameter.
3. ZXR10 router/Ethernet switch allows the command or key-
word to be abbreviated into a character or character string that
uniquely identifies this command or keyword. For example, the
show command can be abbreviated to sh or sho.
4. The user interface supports the function of recording input
commands. A maximum of ten history commands can be
recorded. The function is very useful in re-invocation of a long
or complicated command or ingress.
To re-invoke a command from the record buffer, conduct one
of the following operations, as shown below.
Command
Press CTRL-P or the
up arrow key
Press CTRL-N or the
down arrow key
In any mode, execute the show history command to list the
latest commands input in this mode.

Command Mode

The command modes in this manual are shown below.
Mode Prompt
Exec
ZXR10>
mode
Privi-
ZXR10#
leged
mode
Global
ZXR10(config)#
config-
uration
mode
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 1 Command Introduction
Function
Re-invokes the latest command in the
record buffer. Repeat these keys to
invoke old commands forwards.
Rolls the commands downward. When the
last command line is reached, one more
operation will roll the commands from the
begging of the buffer cyclically.
Admis- Entry
sion Command
Mode
enters directly
after logging
the system
Exec enable
mode
Privi-
configure
leged
terminal
mode
Functions
Views simple
information
Configures
system
parameters
Configures
global service
parameters
3