Mpls Oam(Interface Configuration); Mpls Static Tunnel - Zte ZXR10 Command Manual

ZXR10 Command Manual (MPLS Volume)
Purpose
Command Modes
Syntax
Defaults
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Syntax
Description
80 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config)#mpls oam
mpls oam(Interface
Configuration)
Use this command to enable MPLS OAM. If not enabling the related
MPLS OAM, the configuration does not take effect. Disable MPLS
OAM in tunnel with the no command.
Tunnel interface configuration
mpls oam
no mpls oam
MPLS OAM is disabled by default.
enable
Enables MPLS traffic engine in global configuration firstly. This
command takes effect when the tunnel is UP. If the configuration
information is not complete, the configuration is unsuccessful.
This example describes how to enable MPLS OAM in tunnel inter-
face.
ZXR10(config)#interface tunnel5
ZXR10(config-if)#mpls oam

mpls static tunnel

Use this command to set static tunnel lsp information. Delete the
configuration with the no command.
Tunnel interface configuration
mpls static tunnel <tunnel-id> ingress <lsr-id> egress <lsr
-id>[in-port <if-name> in-label <label>][out-port <if-name>
out-label <label>][next-hop <ip-address>]
no mpls static tunnel <tunnel-id> ingress <lsr-id> egress<ls
r-id>
MPLS OAM is disabled by default.
<tunnel-id>
ingress <lsr-id>
egress <lsr-id>
in-port <if-name>
Enables STP tunnel in vfi.
Static lsp mark
Static lsp ingress router-id
Static lsp egress router-id
In-port name