Rate-Limit(Global Configuration) - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
rate-limit(Global
Configuration)
Use this command to configure interface input or output flow in-
spection policy. Cancel the settings with the no form of this com-
mand.
Global configuration
rate-limit vpls<vpls-name>{input | output {all | single}}{un
icast | broadcast | unknown}<bps><burst-normal><burst-m
ax> conform-action <action> exceed-action <action>
no rate-limit vpls<vpls-name>{input | output {all | single}{u
nicast | broadcast | unknown}
<vpls-name>
input |output
all | single
unicast | broadcast
| unknown
<bps>
<burst-normal>
<burst-max>
conform-action
<action>
exceed-action
<action>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 QoS configuration(Router Series)
VPLS name
Input or output
The whole VPLS | each member of VPLS
Unicast packet| broadcast packet|unknown
type
Average rate, unit: bits/s, range:
8000~2000000000
Normal burst, in bytes, range:
2000~512000000
Maximal burst, in bytes, range;
2000~1024000000
Actions for the packet matching the
designated rate:
drop: Discards the packet
continue: Evaluates the next rate-limit
command
transmit: Sends the packet
set-dscp-continue: Sets a DSCP value (0
~ 63) and evaluates the next rate-limit
command
set-dscp-transmit: Sets a DSCP value (0 ~
63) and sends the packet
set-prec-continue: Sets an IP precedence
value (0 ~ 7) and evaluates the next rate-limit
command
set-prec-transmit: Sets an IP precedence
value (0 ~ 7) and sends the packet
Actions for the packet exceeding the
designated rate:
drop: Discards the packet
continue: Evaluates the next rate-limit
command
75