Supervisor/User Password Setting - ICP Electronics ROCKY-3786EV User Manual

4.14 Supervisor/User Password Setting

The user can set either supervisor or user password, or both of
then. The differences between are:
Supervisor Password : for
User Password
If this function is enabled, the following message will appear to
guide the user to create a password.
ENTER PASSWORD:
Type the password, up to eight characters in length, and press
<Enter>. The password typed now will clear any previously
entered password from CMOS memory. The user will be asked
to confirm the password. Type the password again and press
<Enter>. The user may also press <Esc> to abort the selection
and not enter a password.
To disable a password, just press <Enter> when the user are
prompted to enter the password. A message will confirm the
password will be disabled. Once the password is disabled, the
system will boot and the user can enter Setup freely.
PASSWORD DISABLED:
When a password has been enabled, the user will be prompted
to enter it every time the user try to enter Setup. This prevents
an unauthorized person from changing any part of the user's
system configuration.
entering
settings of the system.
: for just entering the system but does
not have the privilege to change any
settings of the system.
and changing the
55