Supervisor/User Password Setting - ICP Electronics ROCKY-3732EVS Manual

4.14 Supervisor/User Password Setting

You can set either supervisor or user password, or both of then. The
differences between are:
supervisor password :
can enter and change the options of the setup menus.
user password
just can only enter but do not have the right to change the options of
the setup menus. When you select this function,
message will appear at the
creating a
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>.
The password typed now will clear any previously entered password
from CMOS memory. You will be asked to confirm the password.
Type the password again and press <Enter>. You may also press
<Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to
enter the password. A message will confirm the password will be
disabled. Once the password is disabled, the system will boot and you
can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it
every time you try to enter Setup.
person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also require the
BIOS to request a password every time your system is rebooted. This
would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS
Features Setup Menu and its Security option (see Section 3). If the
Security option is set to password will be required both at boot and at
:
center of the screen to assist you in
password.
This prevents an unauthorized
54
the following