6 - 4
MC70 User Guide
Tap
.
3.
ok
A dialog box displays indicating that the EDA must be reset for the change to take effect. Tap
4.
Perform a warm boot.
5.
Single Slot USB/Serial Cradle
This section describes how to use a Single Slot USB/Serial cradle with the EDA. For USB communication setup
procedures refer to the MC70 Integrator Guide.
The Single Slot USB/Serial Cradle:
• Provides 5.4 VDC power for operating the EDA.
• Synchronizes information between the EDA and a host computer. Refer to the MC70 Integrator Guide for
information on setting up a partnership between the EDA and a host computer.
• Charges the EDA's battery.
• Charges a spare battery.
H
INWEIS
Charging the EDA Battery
Connect the cradle to power. Insert the EDA into the EDA slot to begin charging.
Figure 6-4
EDA Battery Charging
Use only an approved power supply output rated 12 Vdc and minimum 3.33A. The power supply is
certified to EN60950 with SELV outputs. Use of an alternative power supply will invalidate any
approval given to this device and may be dangerous.
Charge Status LED
.
ok