Bluetooth Connection - Motorola MC70 Integration Manual

8 - 4 MC70 Integrator Guide
Troubleshooting the EDA (Continued)
Table 8-1
Problem
The EDA does not
accept scan input.

Bluetooth Connection

Troubleshooting Bluetooth Connection
Table 8-2
Problem
EDA cannot find
any Bluetooth
devices nearby.
When trying to
connect a Bluetooth
phone and EDA, the
phone thinks a
previously paired
EDA is used.
Cause
Scanning Load a scanning application on the EDA. See the system
application is not administrator.
loaded.
Unreadable bar Ensure the symbol is not defaced.
code.
Distance between Place the EDA within proper scanning range.
exit window and bar
code is incorrect.
EDA is not Program the EDA to accept the type of bar code scanned.
programmed for the
bar code type.
EDA is not If the EDA does not beep on a good decode, set the
programmed to application to generate a beep on good decode.
generate a beep.
Battery is low. If the scanner stops emitting a laser beam or aiming pattern
upon a trigger press, check the battery level. When the battery
is low, the scanner shuts off before the EDA low battery
condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Symbol Technologies.
Cause
Too far from other
Bluetooth devices.
The Bluetooth device(s)
nearby are not turned on.
The Bluetooth device(s)
are not in discoverable
mode.
The phone remembers
the name and address of
the EDA it last paired
with via the Bluetooth
radio.
Solution
Solution
Move closer to the other Bluetooth device(s), within a
range of 10 meters.
Turn on the Bluetooth device(s) to find.
Set the Bluetooth device(s) to discoverable mode. If
needed, refer to the device's user documentation for help.
Manually delete the pairing device and name from the
phone. Refer to the phone's user documentation for
instructions.