Threader; Feed-Dog Position In Stitch Plate - Fritz Gegauf Bernina artista 630 Service Manual

5.20 Threader

Standard:
•
Remove needle and attach the threader gauge
(030883.50.00) in its place.
•
Set needle to upper dead centre.
•
Push threader downward until threader head turns
in flush under the gauge.
Correction:
•
Loosen screw (67) on the guide piece.
•
The threader head can be properly adjusted by
moving it up or down, as appropriate.
•
Retighten guide piece screw (67).
Important: Don't turn needle bar.
Check basting device by model 640.
Threader gauge 030883.50.00

5.21 Feed-dog position in stitch plate

Standard:
The feed-dog must be equidistant from each side of the stitch plate.
Correction:
•
Loosen screw (93).
•
Move feed-dog carrier shaft (94) sideways into the required position.
•
Retighten screws (93).
Check:
•
When the feed dog is lowered, it must drop freely.(Sewing to darning)
•
When switched from darning to sewing and
the hand wheel is turned the feed dog must
jump up
equidistant
Service-Manual_artista_630_640_english_V4.01_032069_50_04.doc
67
94
93
64
57