Client - D-Link DAP-1360 User Manual

DAP-1360 Wireless N 300 Access Point & Router
User Manual

Client

On the Wi-Fi / Client page in the access point mode, you can configure the device as a client to
connect to a wireless access point.
The "client" function in the access point mode allows using DAP-1360 as a wireless client and a
wireless repeater.
To use the access point as a wireless repeater, you need to configure the same parameters of the
wireless connection (the name of the wireless network, encryption parameters, and the channel) for
DAP-1360 and the remote access point.
To use the access point as a wireless client, you need to configure the same channel of the wireless
connection for DAP-1360 and the remote access point. Other parameters of the wireless network of
DAP-1360 do not depend upon the settings of the remote access point.
Figure 51. Connecting DAP-1360 in the access point mode as a client.
To allow the devices from the LAN of DAP-1360 to obtain the IP addresses from the DHCP server
of the remote access point or network, it is necessary to disable the built-in DHCP server of the
device. To do this, proceed to the Net / LAN page; then in the DHCP server section, in the Mode
drop-down list, select the Disable value and click the Save button.
Page 69 of 212
Configuring Device (Access Point Mode)