D-Link DAP-1360 User Manual page 169

DAP-1360 Wireless N 300 Access Point & Router
User Manual
Parameter
TX Power
BG Protection
Bandwidth
TX Preamble
When you have configured the parameters, click the Change button.
The transmit power (in percentage terms) of the access point.
The 802.11b and 802.11g protection function is used to minimize
collisions between devices of your wireless network.
Select a value from the drop-down list.
Auto: The protection function is enabled and disabled automatically
depending on the state of the network (this value is recommended if
your wireless local area network consists of both 802.11b and
802.11g devices).
Always On: The protection function is always enabled (this setting
can substantially lower the efficiency of your wireless network).
Always Off: The protection function is always disabled.
The channel bandwidth for 802.11n devices.
20MHz: 802.11n devices operate at 20MHz channels.
40MHz: 802.11n devices operate at 40MHz channels.
20/40MHz -: 802.11n devices operate at 20MHz and 40MHz
channels (the channel is combined with the previous adjacent
channel).
20/40MHz +: 802.11n devices operate at 20MHz and 40MHz
channels (the channel is combined with the next adjacent channel).
This parameter defines the length of the CRC block sent by the
access point when communicating to wireless devices.
Select a value from the drop-down list.
Long Preamble.
Short Preamble (this value is recommended for networks with
high-volume traffic).
Page 169 of 212
Configuring Device (Router Mode)
Description