D-Link DAP-1360 User Manual page 35

DAP-1360 Wireless N 300 Access Point & Router
User Manual
Click the Reboot line if you have already saved the access point's settings.
Click the Save&Reboot line to save new settings and immediately reboot the access point.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the access point) to your PC. Also you can save the access point's configuration to your PC via the
Backup button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware WPS/RESET button. The button
is located on the back panel of the access point. Push the button (with the device turned on) and
hold for 3 seconds, then release it. Wait for about 30 seconds. Now you can access the web-based
interface of the access point using the default IP address, username and password.
When you have configured all needed settings, click the Logout line.
Figure 25. The top-page menu.
Page 35 of 212
Installation and Connection