Using Wps Function Via Web-Based Interface; Using Wps Function Without Web-Based Interface - D-Link DAP-1360 User Manual

DAP-1360 Wireless N 300 Access Point & Router
User Manual

Using WPS Function via Web-based Interface

To add a wireless device via the PIN method of the WPS function, follow the next steps:
1. Select the WPS Enable checkbox.
2. Click the Change button.
3. Select the PIN value from the WPS Method drop-down list.
4. Select the PIN method in the software of the wireless device that you want to connect to the
access point's WLAN.
5. Click the relevant button in the software of the wireless device that you want to connect to
the WLAN.
6. Right after that, enter the PIN code specified on the cover of the wireless device or in its
software in the PIN Code field.
7. Click the Connect button in the web-based interface of the access point.
To add a wireless device via the PBC method of the WPS function, follow the next steps:
1. Select the WPS Enable checkbox.
2. Click the Change button.
3. Select the PBC value from the WPS Method drop-down list.
4. Select the PBC method in the software of the wireless device that you want to connect to the
access point's WLAN.
5. Click the relevant button in the software or press the WPS button on the cover of the
wireless device that you want to connect to the WLAN.
6. Click the Connect button in the web-based interface of the access point.

Using WPS Function without Web-based Interface

You can add a wireless device to the access point's WLAN without accessing the web-based
interface of the access point. To do this, you need to configure the following access point's settings:
1. Specify corresponding security settings for the wireless network of the access point.
2. Select the WPS Enable checkbox.
3. Click the Change button.
4. Save the settings and close the web-based interface (click the Save line in the top-page
menu displayed when the mouse pointer is over the System caption, then click the Logout
line).
Page 164 of 212
Configuring Device (Router Mode)