Installation Preparation; Cabling Recommendations And Cautions; About The Rj45 Ethernet Connection - Honeywell ACUIX Installation And Configuration Manual

Installation Preparation

Cabling Recommendations and Cautions

About the RJ45 Ethernet Connection

Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
In this section:
• Cabling Recommendations and
• About the RJ45 Ethernet
• General Cautions and Notes for All Cable
• Maximum Cabling Distances, page
• Power Distances and Supplies, page
• Video CAT5 or Coaxial
• Coax Control, page 32
• RS485 Twisted-Pair Telemetry, page
Cable preparation should be completed prior to the installation. Each dome requires
24 VAC at 1.9A. The power supply should be located as close to the dome as possible for
service and electrical isolation purposes.
If required, refer to other hardware installation guides to determine cabling requirements
based on the individual configuration.
For all types, see Step 5: Connect the Field and Terminal Block
The RJ45 connector located on the housing interface board is for production use and
permits the firmware updates using a crossover cable and a PC. Honeywell recommends
you DO NOT connect your network to the RJ45 connector. It does not damage the dome,
but may negatively affect the network.
Cautions, page 27
Connection, page 27
Installations, page
28
29
Cables, page 30
32
2
28
Wiring, page 54.
27