Hdxg Cameras: Configuring Camera Settings; Turning Motion Detection On Or Off; Table 5-1 Hdxg 35X Camera Feature Dependencies - Honeywell ACUIX Installation And Configuration Manual

Configuration
Task/Action (with Default)

Turning Motion Detection ON or OFF

1. Select 5 Camera Options
The message This will Disable Motion Detection.
Are you sure that you want to do this? displays.
2. Select Y (yes) to disable motion detection or N (no) to cancel.
3. Select ON or OFF.
• If set to ON, interlace scanning, EIS and the default
functions are all automatically disabled.
• If set to ON and an operator sends a command to the
dome, then motion detection is automatically set to OFF
and disabled. The operator must access the setup menu to
re-enable it.
• If set to ON and manual operation is in progress, the
feature is disabled for 30 seconds and returns to normal
operation after the PTZ operation concludes.

HDXG Cameras: Configuring Camera Settings

86

9 Motion Detection.
Note The following tasks are applicable only to the HDXG camera models.
Table 5-1 HDXG 35X Camera Feature Dependencies
If:
Motion detection is enabled
Image stabilization is enabled
Interlace scanning is enabled
Wide Dynamic Range (WDR)
is enabled
Notes
Available with camera models HDXJ,
HDXF and HDXG (NOT HDXA).
When motion is detected, the message
Motion Detected is displayed on the
monitor and remains on the video until
the dome receives a pan, tilt, or zoom
command.
Motion detection is automatically
disabled as soon as motion is detected to
avoid multiple triggers from the same
event. The feature is turned on again after
a one minute delay of any event.
If the dome is in IntelliBus protocol, for
each Motion Detect Event an IntelliBus
Motion Detect message is sent to the
IntelliBus master.
Then:
Interlace scanning and image stabilization are
disabled.
Motion detection is disabled.
Wide Dynamic Range (WDR) and motion detection
are disabled.
Interlace scanning must be disabled and the
ACUIX must be in auto iris mode.