Configure The Paging Amplifier Parameters - CyberData 11085 Operation Manual

2.3 Configure the Paging Amplifier Parameters

To configure the Paging Amplifier online, use a standard web browser.
Configure each Paging Amplifier and verify its operation before you mount it. When you are ready
to mount a Paging Amplifier enclosure, refer to
All Paging Amplifier are initially configured with the default IP settings indicated in
When configuring more than one Paging Amplifier, attach the Paging Amplifiers to the network one
at a time to avoid IP address conflicts.
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway
a. Default if there is not a DHCP server present.
Operations Guide
Table 2-8. Factory Default Settings
Parameter
a
a
a
930363B
Installing the VoIP V2 Paging Amplifier
Configure the Paging Amplifier Parameters
Appendix A, "Mounting the Amplifier"
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
for instructions.
Table 2-8.
CyberData Corporation
16