Table of Contents
Advertisement
MAXI 6560 Series User's Guide
Power Management Setup
This category determines how much power consumption for system after selecting
below items. Default value is Disable. See Page 4-17 to Page 4-20 for details.
PNP/PCI Configuration
This category specifies the assignment of all the IRQ's and DMA's. See Page
4-21 to Page 4-22 for details.
Load BIOS Defaults
BIOS defaults indicates the most appropriate value of the system parameter which
the system would be in minimum performance. The OEM manufacturer may change
the defaults through MODBIN before the binary image burn into the ROM.
Load Setup Defaults
Chipset defaults indicates the values required by the system for the maximum
performance. The OEM manufacturer may change to defaults through MODBIN
before the binary image burn into the ROM.
Integrated Peripherals
This category allows you to set up all the on board I/O controllers like IDE, SCSI,
FDC, etc,. See Page 4-23 to Page 4-25 for details.
Supervisor/User Password
Change, set, or disable password of supervisor or user. It allows you to limit access
to the system and Setup, or just to Setup. See Page 4-26 for details.
IDE HDD Auto Detection
Automatically configure hard disk parameters. See Page 4-27 to Page 4-29 for details.
HDD Low Level Format
Hard disk low level format utility. See Page 4-30 to Page 4-31 for details.
Save & Exit Setup
Save CMOS value changes to CMOS and exit setup.
Exit Without Saving
Abandon all CMOS value changes and exit setup.
BIOS Setup
4-
5
Advertisement
Table of Contents
