Swap Floppy Drive; Boot Up Floppy Seek; Boot Up Numlock Status; Gate A20 Option - Nexcom MAXI 6560 User Manual

MAXI 6560 Series User's Guide
This category determines which drive computer searches first for the disk operating
system (i.e., DOS). Default value is A,C, SCSI.
A, C, SCSI
C, A, SCSI
C, CDROM, A
CDROM, C, A
D, A, SCSI
E, A, SCSI
F, A, SCSI
SCSI, A, C
SCSI, C, A
C only
LS/ZIP, C

Swap Floppy Drive

This item allows you to determine whether enable the swap floppy drive or not.
The choice: Enabled/Disabled (Default).

Boot Up Floppy Seek

During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks.
360K type is 40 tracks while 760K, 1.2M and 1.44M are all 80 tracks.
Enabled (Default)
Disabled

Boot Up NumLock Status

The default value is On.
On (Default)
Off

Gate A20 Option

Normal
Fast (Default)
BIOS Setup
Default
BIOS searches for floppy disk drive to determine if it is 40 or
80 tracks. Note that BIOS can not tell from 720K, 1.2M or
1.44M drive type as they are all 80 tracks.
BIOS will not search for the type of floppy disk drive by
track number. Note that there will not be any warning
message if the drive installed is 360K.
Keypad is number keys
Keypad is arrow keys
The A20 signal is controlled by keyboard controller or
chipset hardware.
Default : Fast. The A20 signal is controlled by Port 92 or
chipset specific method.
4- 11