Replacing The Usb Cable - Intel C50277-001 User Manual

3 Maintaining Your Server

Replacing the USB Cable

1. Remove the left access cover.
2. Remove the bezel.
3. Disconnect the existing USB cable from the server board.
4. Disconnect the bracket the attaches the USB cable to the front of the chassis.
5. Remove all add-in boards.
NOTE
When removing a full-length add-in card, you must pull back on the latch on
the plastic card guide at the front of the chassis to release the card from the
card guide.
6. Push down on the latches for the add-in board retention bracket at the front of the chassis to
disengage it.
7. Tip the retention bracket slightly forward to create a gap between the top of the device and the
chassis frame.
8. Slide the USB cable out through the hole at the front of the chassis, indicated by the letter A in
the figure below.
9. Insert the replacement USB cable through the hole at the front of the chassis.
10. Route the cable next to over the add-in board retention bracket as shown in the figure below.
11. Attach the USB cable to the server board.
12. Install the bracket over the USB port at the front of the chassis.
13. Reinstall all add-in cards.
14. Replace the bezel.
15. Replace the access cover.
Intel® Entry Server Chassis SC5275-E User Guide
3
A
2
1
Figure 23. Installing the USB Cable
1
TP00079
36