Table of Contents
Advertisement
7.9
Administration
You can modify the user profile, security, SNMP (Sample Network Management Protocol),
supervisor information and SNTP (Simple Network Time Protocol) in admin.
The route is enable
For configuration the parameters, move the cursor " >> " to admin and press enter.
>> user
security
snmp
passwd
id
sntp
7.9.1 User Profile
You can use user command to clear, modify and list the user profile. You can setup at most five
users to access the router via console port or telnet in user profile table however users who have
the supervisor password can change the configuration of the router. Move the cursor " >> " to user
and press enter key.
>> clear
modify
list
You can delete the user by number using clear command. If you do not make sure the number of
user, you can use list command to check it. Modify command is to modify an old user information
or add a new user to user profile.
To modify or add a new user, move the cursor to modify and press enter.
----------------------------------------------------------------------
Command: admin user modify <1~5> <more...>
Message: Please input the following information.
Legal access user profile number <1~5> : 2
----------------------------------------------------------------------
The screen will prompt as follow.
>> Attrib
Profile
There are two UI mode, command and menu mode, to setup the router. We will not discuss
command mode in this manual.
Move the cursor to Attrib to change the UI mode on this profile
Move the cursor to Profile and press enter, you can change the username and their password on
this profile.
admin.
Manage user profile
Setup system security
Configure SNMP parameter
Change supervisor password
Change supervisor ID
Configure time synchronization
Clear user profile
Modify the user profile
List the user profile
UI mode
User name and password
GRT-504 4-Wire G.SHDSL.bis Firewall Router User's Manual
125
Advertisement
Table of Contents
