Table of Contents
Advertisement
7
Configuration via Serial Console or Telnet with
Manu Driven Interface
In this section, the detail of menu-driven user interface will be described below line by line
7.1
Introduction
7.1.1 Serial Console
Check the connectivity of the RS-232 cable. Connect the male 9-pin end of console port of the
router and connect the female end to a serial port of your computer.
Start your terminal access program by VT100 terminal emulation with the following parameters:
Press the SPACE key until the login screen appears. When you see the login screen, you can
logon to Router.
Note: Only SPACE key invoke the login prompt. Pressing other keys does not work.
User: admin
Password: *****
Note: The factory default User and Password are "admin" both.
7.1.2 Telnet
Make sure the correct Ethernet cable connected the LAN port of your computer to this Router. The
LAN LNK LED indicator on the front panel shall light if a correct cable is used. Starting your Telnet
client with VT100 terminal emulation and connecting to the management IP of Router, wait for the
login prompt appears. Input User and Password after login screen pop up,
User: admin
Password: *****
Note: The default IP address is 192.168.0.1.
Parameter
Baudrate
Data Bits
Parity Check
Stop Bits
Flow-control
105
GRT-504 4-Wire G.SHDSL.bis Firewall Router User's Manual
Value
9600bps
8
No
1
No
Advertisement
Table of Contents
