Table of Contents
Advertisement
• RTS/CTS Threshold
• Distance
• Aggregation
Wireless Traffic Shaping
• Enable Traffic Shaping
• Incoming Traffic Limit
• Outgoing Traffic Limit
• Total Percentage
• SSID1 to SSID4
Client Limit: This option is only available in AP and WDS AP modes.
• Frequency
• Enable
• Max Client
• Accept
• Cancel
5.6 Management
On this page, you can configure the system settings for management purposes, including Management VLAN
settings, Time settings, Password settings, SNMP settings, CLI settings, Wi-Fi schedule, Firmware upgrade,
Configuration backup and restore, Factory default, and Auto reboot.
5.6.1 Administration (Password Settings)
Click "Management Administration" to configure username and password of the login account.
regulation.
When the length of a data packet exceeds this value, the device will send
an RTS frame to the destination wireless node, and the latter will reply
with a CTS frame, and thus they are ready to communicate. The default
value is 2346. A small number causes RTS/CTS packets to be sent more
often and consumes more bandwidth.
Specify the distance between the master AP and slave AP. Longer
distances may drop high-speed connections.
A part of the 802.11n standard that allows sending multiple frames per
single access to the medium by combining frames together into one larger
frame. It creates the larger frame by combining smaller frames with the
same physical source, destination end points, and traffic class (QoS) into
one large frame with a common MAC header. This option reduces the
number of packets, but increases packet sizes.
Enable or disable the regulation of packet flow leaving an interface for
improved QoS.
Specify the wireless transmission speed used for downloading.
Specify the wireless transmission speed used for uploading.
Specify the total percentage of the wireless traffic that is shaped.
Specify the percentage of the wireless traffic that is shaped for a specific
SSID.
Display the frequency of the device's radio interface.
Click to enable the client limit function.
Specify the max. client quantity that is allowed to connect to the radio
interface.
Click Accept to apply all changes.
Click Cancel to cancel the settings.
-85-
User Manual of WAP-200N/WBS-200N
Advertisement
Table of Contents
