Setup; Mode; Shdsl.bis - Planet GRT-504 User Manual

7.12

Setup

All of the setup parameters are located in the subdirectories of setup. Move the cursor " >> " to
setup and press enter.
>> mode

shdsl.bis

wan
bridge
vlan
stp
route
lan
ip_share
firewall
ip_qos
dhcp
dns_proxy
hostname
default

7.12.1 Mode

The product can act as routing mode or bridging mode. The default setting is routing mode. You
can change the system operation mode by using mode command. Move the cursor " >> " to mode
and press enter.
----------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
----------------------------------------------------------------------
7.12.2 SHDSL.bis
You can setup the SHDSL.bis parameters by the command shdsl.bis. Move the cursor " >> " to
shdsl.bis and press enter.
`>> mode
Link
n*64
type
clear
margin
tcpam
There are two types of SHDSL.bis mode, STU-C and STU-R. STU-C means the terminal of central
office and STU-R means customer premise equipment.
Link type will be 2-wire, M-Pair, M-Pair (Conexant), Auto_Fall_Back, StandBy, and Multi-link.
4-wire product can be worked under 2-wire mode.
Switch system operation mode
Configure SHDSL.bis parameters
Configure WAN interface profile
Configure transparent bridging
Configure virtual LAN parameters
Configure bridge STP parameters
Configure routing parameters
Configure LAN interface profile
Configure NAT/PAT parameters
Configure Firewall parameters
Configure IP QoS parameters
Configure DHCP parameters
Configure DNS proxy parameters
Configure local host name
Restore factory default setting
Configure SHDSL.bis mode
Configure SHDSL.bis link
Configure SHDSL.bis data rate
Configure SHDSL.bis annex type
Clear current CRC error count
Configure SHDSL.bis SNR margin
Configure shdsl.bis TCPAM type
GRT-504 4-Wire G.SHDSL.bis Firewall Router User's Manual
134