Ir Transmission Delay; Ur2 Duplex Mode; Use Ir Pins; Parallel Port Mode - Albatron PX875P User Manual

RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if "UART Mode
Select" is set to "ASKIR" or "IrDA". Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field only con
Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disab

UR2 Duplex Mode

Select the transmission m
bi-directional transmission. Half-duplex m
T his field only configurable if "UART Mode
Options: Half (default)、Full

Use IR Pins

Consult your IR peripher al documentation to select the correct setting of the TxD and RxD signals.
This field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: Full、Half (default)
O nboard Parallel Port
Select an address and correspon
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled

Parallel Port Mode

T his option allows you to select a parallel port mode for the onboard parallel port.
Options: ECP(default)
EPP
SPP
ECP+EPP
Normal

EPP Mode Select

Select EPP port type 1.7 or 1.9. This field is only configurable if "Parallel Port Mode"
or "ECP+EPP". Options: EPP 1.9(default)、EPP 1.7
ode used by the IR interface. Full-duplex mode permits simultaneous
ode permits transmission in only one direction at a time.
Select" is set to "ASKIR" or "IrDA".
ding interrupt for the onboard parallel port.
Extended Capabilities Port.
Enhanced Parallel Port.
Standard Printer Port.
ECP & EPP mode.
38
PX875P PRO/ PX875P
figurable if "UART
led
is se t to "EP P"