Table of Contents
Advertisement
Appendix III: Installing a Windows
to the SATA HDD
Please refer to the steps below to install a windo
1.
Make sure that the "On-Chip Serial ATA" option is set to " Combined Mode " in the BIOS
Setup Utility.
BIOS Setup Utility -> Integrated Peripherals
ATA
"Combined Mode"
2.
Make sure that either the "Serial ATA Port0 Mode" or "Serial AT
set to "Primary Master" in the BIOS Setup Utility. Note that y
Port1 depending on which SATA drive you are installing the OS to.
BIOS Setup Utility -> Integrated Peripherals
Port0/1 Mode
3.
Save all BIOS configurations and exit the BIOS setup utility.
4.
Place the Windows
installation process. During the installation you will see that the SATA devi
assigned to the C: drive. Continue and complete the installation of the Windows
5.
If you are installing Windows
"Auto＂or"Enhanced Mode＂in the BIOS Setup Utility in order for all of the SATA and
IDE devices to be visible.
BIOS Setup Utility -> Integrated Peripherals
ATA
"Enhanced Mode" or "Auto"
"Primary Master"
®
98/Me/2000/XP CD into the CD-ROM drive to begin the OS
®
XP, you must now set the"On-Chip Serial ATA＂option to
58
PX875P PRO/ PX875P
®
®
ws OS to the SATA HDD
OnChip IDE Device
On-Chip Serial
A Port1 Mode" option is
ou need to set either Port0 or
OnChip IDE Device
OnChip IDE Device
On-Chip Serial
OS
Serial ATA
ce has been
®
OS.
Advertisement
Table of Contents
